Distributing the Transport Domain Configuration


After a change is made to the transport domain configuration, this must be distributed to all R/3 Systems in the transport domain. Each time you make a change to the domain controller, a dialog box is therefore displayed asking about distributing the configuration.

You can therefore make several changes to the domain controller and distribute all these configuration changes after that in one go.


To distribute the configuration later, proceed as follows:

  1. Log onto the R/3 System acting as the domain controller.
  2. Call transaction STMS.
  3. Choose Overview ® Systems.
  4. This takes you to the system overview.

  5. Choose Extras ® Distribute TMS conf.

The configuration of the transport domain is now distributed to all R/3 Systems. The status bar indicates in which R/3 System the configuration is being adapted.

If a controller relocation was not performed completely earlier because not all R/3 Systems could be reached, it is not possible to distribute the configuration. Instead, you are advised to complete the controller relocation.